Xbox 360 Problems

In the three and half years since its launch, lots of people have reported many Xbox 360 problems in the console. The most dreaded among these is the 3 red lights flashing commonly known as ‘Red Ring of Death” that signifies complete hardware failure.

Electronics industry sources have tried to find the causes behind various Xbox 360 problems that the console shows up:

- One of the major Xbox 360 problems is that of overheating. This problem may have originated from the fact that in its attempt to save on cost Microsoft built the graphics chip in-house instead of outsourcing it to an application-specific integrated circuit (ASIC) vendor. Microsoft eventually got the chip redesigned from an ASIC vendor so that it would give out less heat.

Click Here to Fix Your Xbox 360 In 1 Hour Now !

- Another cause of the general hardware Xbox 360 problems is thought to be the cold solder joints. Various Xbox 360 problems arise with soldered joints when parts being joined do not exceed the solder’s liquidus temperature (above which a substance is a stable liquid) leading to a ‘cold solder.’ This can lead to air bubbles or voids, which tend to crack due to the temperature changes within the console. It has also been suggested that the wrong type of lead-free solders have been used, which leads to the solders becoming brittle.

- In a number of Xbox 360 consoles general hardware failure has also been known to be due to the Nyko Intercooler designed to reduce the internal operating temperature of the Xbox 360.

- Inadequate cooling results in heating up of the inside of the gaming console. The temperatures can be abnormally high when used for prolonged periods. This results in solder joints of the central and graphics processing units and the motherboard breaking open. To make room for the DVD drive Microsoft reduced the heat sink, metal conductor specially designed to conduct or radiate heat. Although the Xbox 360 also has vents for discharge of heat and fans for dispersing heat these become insufficient as the potential for heat build up is great if the console is used for long periods.

- Immediately after release the Xbox 360 many customers also reported other Xbox 360 problems like scratches on discs. On investigation it was found that since the discs used in Xbox were not firmly secured in place moving or tilting the console while in use caused disc scratching.

Some manufacturers have come up with external cooling devices that can be attached to the console but as these use the Xbox 360’s power brick they may cause the power brick to overheat and damage the internal microprocessors. Nyko, the original third party manufacturer of the intercooler, has stated that the problem has been rectified and does not exist in the new updated models that have their own power source. However, Microsoft does not accept these and considers it as an infringement of terms of warranty. Both Microsoft and some game publishers, however, have specific programs for replacement of scratched discs.

At one time the Xbox 360 problems reached such heights that major repair facilities stopped repairing the console because the Xbox 360 problems would re-emerge even after repair. The extent of the problem also motivated Microsoft to create an internal account of $1 billion specifically devoted to address these Xbox 360 problems.

Want to easily fix your xbox 360 in less than 1 hour .. and without spending $140 now?

If the answers to any of the two questions above is a resounding “YES”, then I strongly recommend you check out 3RedLightFix.com .

This essential guide reveals an amazingly simple method to easily fix your xbox 360..guaranteed. Click here to go check it out now!.